Welcome to our resource for MG Car Information.
MG MGA - Stiff Second Gear
I have a 1961 MGA with a 5 speed tranny.  I've noticed that when I first start driving in the morning, second gear is a little stiff.  Or rather, it doesn't drop into gear like it does after it's warmed up a bit.  I've noticed this much more on colder mornings.  Is this normal, or am I facing possible problems later on?
![]()  | 
| S. H. Shanks | 
| SH, I recently installed a "rebuilt" 5 speed tranny. I also have a similar problem. When cold the tranny is difficult to shift into 2nd and a little hard to shift into 3rd. I was told I put in the wrong oil. I filled with Mobil 1 synthetic 75w 90. I hope that is the problem. I was able to suck the oil out by cutting a access hole in the tranny tunnel above and to the rear of the filler hole for the tranny. This gave me a fair view inside the tranny through the filler plug hole. Then I pushed a small rigid plastic pipe down into the tranny gearbox, hooked this up to a pump designed to pull motor oil out of marine engines normally to be down the dip stick hole. Next step is to fill with proper fluid. Redline M/T 90 will be used. I will flush it once, running the motor/gearbox while the car is on jackstands. Then sucking that oil out and refilling again with Redline m/t 90. Then get it back on the road, where I hope to find the "rebuilt" tranning is shifting fine. What oil do you have in your tranny? Ray  | 
| Ray Ammeter | 
| Thanks Ray,  I don't know the type of oil in my trans right now.  I only recently acquired the car, and I'm still learning new things about it everyday.  Thank you for the helpful information. Stan  | 
| S. H. Shanks | 
| SH, if it is a standard gearbox it should have engine oil. It may have a heavy gear oil at present. I would drain and refill with the lighter grade oil. Barry.  | 
| BM Gannon | 
| Thank you Barry. S.H.  | 
| S. H. Shanks | 
| Barry He has the Ford Type 9 box by the sound of it. It is specified to take 1.9L of 75W90 semi-synthetic. Putting my lateral thinking hat on, are you you sure it's the gear causing the problem and not a very cold and rigid gear stick boot? The original Type 9 conversion had a long throw gear stick. Accordingly, I found difficulty with some gear changes with the standard boot and a tendency for the boot to pull the stick out of gear when I took my foot off the throttle in 2nd and 3rd. I solved the problem by making a leather boot. I believe that a shorter throw stick mechanism is now offered that cures this problem. Steve  | 
| Steve Gyles | 
| I'm pretty sure it's not the shift boot.  I'm also fairly certain it's in the gear mechanism.  But thank you for your input just the same. S.H.  | 
| S. H. Shanks | 
This thread was discussed between 26/01/2009 and 27/01/2009
MG MGA index
This thread is from the archive. The Live MG MGA BBS is active now.